Left Side Panel - Sony PCM-2000 Operation Manual

2-3-4. Left Side Panel
1D Battery compartment
y@ Battery eject knob
KB DC IN 12V connector
(OG ev wom Siew TS OUT Lic in?
4) WORD SYNC connector
5) LTC OUT connector
6) LTC IN connector Y) MULTI CONNECTOR
@ Battery compartment
Insert NP-1A or NP-1 battery pack (optional).
@ Battery ejection tab
To remove the battery pack, slide the tab in the direction of the arrow.
© 0¢ IN 12Vv (external power input) connector (XLR type, 4-pin)
Connect the DC cord of the AC-500 AC power adaptor when operating the unit on AC
power. Or connect a DC power source whose operating voltage is 12V to 15V (more
than 5A).
@ WORD SYNC input connector (BNC type)
Inputs the word sync signal. When this unit is to be operated in synchronization with
other equipment, this connector inputs the word sync signal. In this case, set the Fs
selector of this unit to suit to the sampling frequency of the word sync signal.
@ LIC OUT (longitudinal time code output) connector (BNC type)
Connect to the input of the external time code reader. This connector outputs the
time code recorded on the tape.
6) LTC IN (longitudinal time code input) connector (BNC type)
Connects to the output of the external time code generator. Time code input to this
unit can be recorded on the tape using the LTC REC key inside the cassette
compartment.
@ MULTI CONNECTOR (60-pin)
This connector is provided to expand the function of the PCM-2000 in the future.
20 (E)