Table of Contents
Advertisement
3-1-3. Writing the Sub Codes
Writing the start ID
With the PCM-2000, the following sub codes can be written when recording analog
input signals.
e Start ID: Indicates a particular location, such as the beginning of a selection.
© Program number:
Indicates the order of the start ID.
© Skip ID: indicates the portion to be skipped during playback.
Among the above three sub codes, the start ID and program number can be written
during recording and playback. The skip !D is writable only during playback*. (On
writing during playback, refer to "Functions using the sub codes".)
With the following operation, the start ID can be written on the desired portion during
recording.
At the point where you want to write the start ID, press ID WRITE in recording mode.
The start ID will be recorded for 9 seconds.
While the start ID is being written, the 1D WRT indicator lights up in the display.
The start ID is not automatically written when the input signal is supplied.
program number.
9 seconds after the previous one. To detect the start IDs
correctly during playback, set them for more than 30
seconds apart.
29 (E)
T
Advertisement
Table of Contents
