Table of Contents
Advertisement
0 MIC POWER (microphone power supply) selector
Selects voltage according to the power requirements of the microphones to be
connected to the MIC/LINE input connector.
Setting
Type of the microphone
Voltage (load)
48V (2mA)
12V (10mA)
12V (10mA)
No power is supplied to the microphone. Set to this position when using
dynamic microphones or microphones with a built-in power source.
Phantom powering
AB feed powering
——-—)
Factory preset setting: OFF
8 INPUT SELECT (analog input select) switch
Sets according to the equipment to be connected to the MIC/LINE input connectors.
sea
Equipment to be connected
External rnIclonene
A
LINE
Analog input signal (line outputs of an analog tape recorder or mixer)
Factory preset setting: LINE
@ Mic Low CUT selector
Lower frequencies of the microphone input signal can be attenuated with this
selector. Set the selector according to the input source.
| Setting
Input source
Voice (12dB/octave HPF below 200Hz)
Music (6dB/octave HPF below 100Hz)
The input signal will not undergo attenuation; it will be flat.
Factory preset setting: OFF
7) MIC ATT (microphone attenuator) selector
Attenuates the microphone input level by 20dB or 40dB. Set to OFF to disengage the
attenuation.
Factory preset setting: OFF
8) MIC/LINE input connectors (XLR-3-31 or equivalent)
Inputs microphone signals or line output signals. After connection, select the input
source with the INPUT SELECT switch @ on the same panel.
Pin assignment of the connector
1: GND | 2: HOT | 3: COLD
19 (E)
T
Advertisement
Table of Contents
