Sony PCM-2000 Operation Manual page 39

Using the skip 1D, you can skip unwanted portion during playback.
Writing the skip ID
The skip ID can be written with its position finely adjusted (rehearsal function).
1 Set the SKIP switch in the cassette compartment to ON.
SKIP indicator is displayed.
2 During playback, press ID WRITE at the position where the skip ID is to be written.
The ID WRT indicator blinks slowly.
The portion for 3 seconds behind the point where the key is pressed is played
back repeatedly.
3 While listening to the repeated sound, adjust the 'repeat end" point by pressing
pp FF or << REW.
Each time the pp FF (forward) or «<q REW (backward) is pressed, the point is
shifted by 0.3 seconds on the tape.
4 when the portion where the skip ID is to be written is decided, press ID WRITE
again.
The ID WRT indicator lights up while the skip ID is being written.
Skipping an unwanted portions
Set the SKIP switch to ON.
SKIP indicator appears in the display.
When a skip ID is detected during playback, the tape skips to the next start ID and
plays back. The SKIP indicator disappears while the start ID is played back (the ID
indicator lights up).
Note on rehearsal
During writing the skip 1D, the skip ID cannot be written if
Repeating the rehearsal operation may damage the tape.
the safety tab of the cassette is open.
Avoid repeating a portion more than 10 times.
37 (E)