Table of Contents
Advertisement
Input level adjustment of the microphone
Connect the microphone to the MIC/LINE input connector, and set the INPUT SELECT
switch to MIC.
Adjust the input level according to the recording source.
Low cutting of the input signal
Input signal of lower frequencies may be heard as a noise. In this case, set the MIC
LOW CUT selector according to the input source to cut the lower frequencies
| Input source | Selector setting
Music
To deactivate this low cut circuit, set the selector to OFF.
Attenuating the input level
{f the recording input level is too high and the sound is distorted, set the attenuating
level to 20 dB or 40 dB using the MIC ATT selector.
26 (E)
Advertisement
Table of Contents
