enphase IQ8MC Installation And Operation Manual page 29

Maximum 5 microinverters per 20 A (max) AC branch circuit
230 VAC (single-phase)/25 A AC branch circuit 400 VAC (three-
phase)
European weighted efficiency
Total harmonic distortion
Ambient air temperature range
Nighttime power loss
Storage temperature range
Compatibility
Dimensions (without mounting brackets)
DC connector type
Weight
IP Rating
Torque specifications for fasteners
(Do not over-torque)
Cooling
Relative humidity range
Approved for wet locations
Altitude
Pollution degree
Standard warranty terms
Compliance
Earthing
Monitoring
Communication
5. Limits may vary. Refer to local requirements to define the number of microinverters per branch in your area.
6. A minimum of two IQ8MC Microinverters shall be required in the system.
29
IQ8MC, IQ8AC, and IQ8HC Installation and Operation Manual
Miscellaneous parameters
IQ8MC-72-M-ACM-INT Microinverter parameters
Features and specifications
IQ8MC-72-M-ACM-INT Microinverter parameters
© 2023 Enphase Energy Inc. All rights reserved.
%
%
°C
-40
mW
°C -40
54-cell/108-half-cell, 60-cell/120-half-cell, 66-
cell/132-half-cell, 72-cell/144-half-cell
212 mm (8.3") x 175 mm (6.9") x 30.2 mm (1.2")
Stäubli MC4
1.1 kg
Outdoor - IP67
•
6 mm mounting hardware: 5 N m
•
8 mm mounting hardware: 9 N m
Natural convection - no fans
4% to 100% (condensing)
Yes
<2600 m
PD3
http://enphase.com/warranty
With IQ Relay:
AS/NZS 4777-2:2020
6
Safety:
EN IEC 62109-1, EN IEC 62109-2
EMC:
EN IEC 61000-3-2, 61000-3-3, 61000-6-2, 61000-6-
3, EN IEC 50065-1, 50065-2-1
EN55011 (at STC within MPP range)
The DC circuit meets the requirements for ungrounded
PV arrays. Ground fault protection (GFP) is integrated
into the Class II double-insulated microinverter.
Enphase Installer Portal and Enphase App. Both
options require an IQ Gateway.
Power line communication (PLC)
12 (L+N)/42 (3L+N)
96.6
<5
60
50
85
November 2023
USM-00006-2.0