Table of Contents
Advertisement
www.ti.com
•
Pattern Display Invert Data – This setting allows the user to invert the data to the DMD. The setting must
be set before any Pattern LUT updates are sent to the DLPC900 and the pattern sequence must be in the
stopped state. This setting is not applicable to Video Mode.
•
DMD Park – This setting allows the user to park and un-park the DMD. Using the isolated Park/Unpark
command is no longer recommended except for debugging purposes. If the Display Mode is set to Pre-stored
pattern mode, Video pattern mode or Pattern On-The-Fly mode, the pattern sequence must be stopped prior
to execution of this command.
DLPU101C – DECEMBER 2020 – REVISED MAY 2023
Submit Document Feedback
DLP® LightCrafter™ Single DLPC900 Evaluation Module (EVM) User's Guide
Copyright © 2023 Texas Instruments Incorporated
Operating the DLP LightCrafter Single DLPC900 EVM
25
Advertisement
Table of Contents
Need help?
Do you have a question about the DLPC900EVM and is the answer not in the manual?