Maintenance Work; Lubricate - SCHUNK KSP3 Assembly And Operating Manual

Maintenance and care

6.4 Maintenance work

6.4.1 Lubricate

28
Alternative lubricant
LINOMAX plus can also be used as an alternative to microGLEIT LP
410. However, the specified clamping forces exclusively refer to
the microGLEIT LP 410 used by SCHUNK. When using LINOMAX plus,
the clamping forces can be lower.
CAUTION
Allergic reactions or irritation due to skin or eye contact with
lubricants on the product.
Wear protective equipment (protective gloves, protective
l
goggles) in case of foreseeable contact with lubricants on the
product (e.g. when lubricating or cleaning)
To maintain reliable function and high quality of the product, it
has to be regularly lubricated. This can be done with a hand
lever press for greases or by means of central lubrication.
Manual lubrication
l
l
l
l
Size Grease quantity (strokes per grease nipple)
64
100
140
160
200
250
315
05.00 | KSP3, KSP3-LH, KSP3-F | TANDEM Clamping Block | en | 1463318
Press grease either into the grease nipples
at the side or front of the respective
supply line (6/7).
Only lubricate in the open position.
After greasing, run through the complete
stroke several times.
Grease to be used and lubrication
intervals, [/ 27].
} 6.3
1
2
2
2
2
3
4