Maintenance And Care; Notes; Maintenance And Lubrication Intervals; Greasing Areas / Lubricants - SCHUNK KSP3 Assembly And Operating Manual

6.1 Notes

6.2 Maintenance and lubrication intervals

6.3 Greasing areas / lubricants

05.00 | KSP3, KSP3-LH, KSP3-F | TANDEM Clamping Block | en | 1463318

6 Maintenance and care

Original spare parts
Only use original spare parts from SCHUNK when replacing
wearing parts/spare parts.
Replacement of the housing and base jaws
The base jaws and the guides in the housing are matched to
each other. To replace these parts, send the entire product to
SCHUNK with a repair order.
Maintenance variant with clamping force maintenance (AS)
The cylinder piston must be disassembled or assembled using a
disassembly and assembly device. We therefore recommend you
have maintenance work and change of seals performed at
SCHUNK.
The following maintenance work should be carried out after the
specified cycle numbers or at the latest after the monthly data.
Maintenance work
Lubricate
Basic cleaning
Leak test
Greasing areas
Sliding surfaces body – base
jaw
Sliding surfaces base jaws –
chuck piston
Lubrication nipple
Central lubrication
All seals
Sliding surfaces cylinder piston
– housing
(Product information about microGLEIT LP 410 can be requested
from SCHUNK).
Maintenance and care
Interval [cycles/month]
10,000 / 1
- / 6
5,000 / 1
Lubricant
microGLEIT LP 410
microGLEIT LP 410
microGLEIT LP 410
microGLEIT LP 410
RENOLIT HLT 2
RENOLIT HLT 2
27