Table of Contents
Advertisement
Safety information
2.1
Information for those responsible for the plant/system
This motor is a partly completed machine in the sense of directive 2006/42/EC ("machinery
directive"), and has been designed and built in compliance with the applicable's health and
safety protection requirements of this directive, including the protection goals of directive
2014/35/EU ("Low-Voltage Directive") regarding electrical hazards. It is intended for use in
industrial plants and systems. Please observe the country-specific regulations when using the
motor outside the European Union. Comply with local and industry-specific safety and
installation regulations.
The persons responsible for the plant must ensure the following:
• Planning and configuration work and all work carried out on and with the machine is only
to be done by qualified personnel.
• The operating instructions are always available when performing any work.
• The technical data as well as the specifications relating to the permissible installation,
connection, ambient and operating conditions as well as the other safety-related data and
notes in these operating instructions are taken into account at all times.
• The specific setup and safety regulations as well as regulations on the use of personal
protective equipment are strictly complied with.
Note
Engage the services and support provided by the local service center (Page 12) for planning,
installation, commissioning and service work.
Further, this machine has been designed, built and tested in accordance with Directive
2014/34/EU ("Explosion Protection Directive") and is intended for use in industrial plants with
a potentially explosive atmosphere (corresponding to the data on the rating plate).
Commissioning in hazardous areas
Only commission the machine if it has been absolutely confirmed that the plant or system is
in full conformance with the valid directive.
When using the machine, carefully comply with country-specific regulations relating to
protection against explosion.
2.2
The 5 safety rules
To ensure your own personal safety as well as to avoid material damage, always comply with
the safety-relevant instructions when carrying out any work. Also carefully comply with the 5
safety rules according to EN 50110-1 "Working in a no-voltage state" in the specified
sequence.
1MB1.33 Eagle Line shaft heights 71 ... 315
Operating Instructions, 08/2023, A5E52990459A
2
17
Advertisement
Table of Contents
