Table of Contents
Advertisement
Safety information
2.1
Information for the nominated person in control of the electrical
installation
This electric machine has been designed and built in accordance with the specifications
contained in Directive 2014/35/EU ("Low-Voltage Directive") and is intended for use in
industrial plants. Please observe the country-specific regulations when using the electric
machine outside the European Community. Follow the local and industry-specific safety and
setup regulations.
The persons responsible for the plant must ensure the following:
● Planning and configuration work and all work carried out on and with the machine is only to
● The operating instructions must always be available for all work.
● The technical data as well as the specifications relating to the permissible installation,
● The specific setup and safety regulations as well as regulations on the use of personal
2.2
The 5 safety rules
For your own personal safety and to prevent material damage when carrying out any work,
always observe the safety-relevant instructions and the following five safety rules according to
EN 50110‑1 "Working in a voltage-free state". Apply the five safety rules in the sequence stated
before starting work.
5 safety rules
1. Disconnect the system.
2. Secure against reconnection.
3. Verify absence of operating voltage.
4. Ground and short-circuit.
5. Provide protection against adjacent live parts.
To energize the system, apply the measures in reverse order.
SIMOTICS FD 1LP1
Operating Instructions 01/2019
be done by qualified personnel.
connection, ambient and operating conditions are taken into account at all times.
protective equipment are observed.
Note
Use the services and support provided by the local service center (Page 163) for planning,
installation, commissioning and service work.
Also disconnect the auxiliary circuits, for example, anti-condensation heating.
2
15
Advertisement
Table of Contents
