Table of Contents
Advertisement
Operation
8.1 Safety instructions for operation
Faults in operation
Any changes with respect to the normal condition can indicate that the machine is not
functioning correctly.
• Higher power consumption, temperatures or vibration levels.
• Unusual noise or smells.
• Monitoring devices respond.
These changes can cause faults which can result in eventual or immediate death, serious
injury or material damage.
• Immediately inform the service personnel.
• If you are in doubt, immediately switch off the machine, carefully observing the system-
specific safety conditions.
Corrosion damage as a result of condensation
Humidity can condense inside the machine if the machine and/or ambient temperatures
fluctuate, for intermittent operation or load fluctuations.
Condensation can accumulate. Moisture can have a negative impact on the winding
insulation or result in damage, such as corrosion.
• Ensure that any condensation can freely flow away.
• If available, remove the screw plugs to drain the water depending on the ambient and
operating conditions.
• If available, reinsert the screw plugs.
If the motor is equipped with drain plugs, then the water can drain away by itself.
Risk of burn injuries as a result of hot surfaces
Individual machine parts can become hot in operation. Burns can result when coming into
contact with these parts.
• Never touch machine parts during operation.
• Allow the machine to cool down before starting work.
• Check the temperature of parts before touching them. If required, wear suitable protective
equipment.
Hazardous substances
Chemical substances required for the setup, operation and maintenance of machines can
present a health risk. Poisoning, skin damage, cauterization of the respiratory tract, and other
health damage may result.
• Carefully comply with the information in these operating instructions and the product
information supplied by the manufacturer.
• Observe the relevant safety regulations and wear the personal protective equipment
specified.
112
1MB1.33 Eagle Line shaft heights 71 ... 315
Operating Instructions, 08/2023, A5E52990459A
Advertisement
Table of Contents
