Removing The Processor Heatsink Module (Phm) From The Motherboard - Supermicro SuperStorageServer 1029P-NES32R User Manual

Removing the Processor Heatsink Module (PHM) from the
Motherboard
Before removing the processor heatsink module (PHM), unplug power cord from the power
outlet.
1. Using a T30 Torx-bit screwdriver, turn the screws on the PHM counterclockwise to
loosen them from the socket, starting with screw marked #4 (in the sequence of 4, 3, 2,
1).
2. After all four screws are removed, wiggle the PHM gently and pull it up to remove it from
the socket.
Note: To properly remove the processor heatsink module, be sure to loosen and remove the
screws on the PHM in the sequence of 4, 3, 2, 1 as shown below.
Removing the screws in
the sequence of 4, 3, 2, 1
#4
#1
Printed Triangle on Motherboard
Chapter 3: Maintenance and Component Installation
#2
#3
After removing the screws, lift the
Processor Heatsink Module off the CPU
socket. Remember to put the plastic
protective cover on top of the CPU socket.
32
CPU Socket
After removing the screws,
lift the Processor Heatsink
Module off the CPU socket.