Installing The Outer Rails Onto The Rack - Supermicro SuperStorageServer 1029P-NES32R User Manual

Installing the Outer Rails onto the Rack

Each end of the assembled outer rail includes a bracket with square pegs to fit into your rack
holes. If you have an older rack with round holes, these brackets must be removed, and you
must use screws to secure the rail to the rack.
Outer Rail Installation
1. Align the square pegs on the back end of the rail with the square holes on the front of
the rack until it clicks (A). Lift the latch upward and push the middle rail to the rear (B).
2. Adjust the rail to reach just past the full depth of your rack. Align the square pegs on
the front end of the rail to the holes on the rack. Turn the latch to the open position and
push the pegs into the front for the rack holes (C).
3. Lock the latch (D).
1
A
1
C
Figure 2-4. Installing the Outer Rails to the Rack
Warning: Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing. Failure to
stabilize the rack can cause the rack to tip over.
Chapter 2: Server Installation
21
1
B
1
D