Table of Contents
Advertisement
should set the master unit effect via its knobs, then the other units (slave) will lighting as the
same.
4.2 DMX Controller
When using a universal DMX controller to control the units, you must set a DMX address from 1 to
512.
Press the MENU button up to when
the display will blink. Use the DOWN/UP buttons to change the DMX 512 address. Once the
address has been selected, press and hold the ENTER button until the display stops blinking or it
will store automatically 30 seconds later. To go back to the functions without any change press the
MENU button again.
If you use please refer to the following diagram to address your DMX512 channel for the first 4
units.
4.3. DMX512 Configuration
2 Channel Mode:
CHANNEL
1
2
is showing on the display. Press the ENTER button and
VALUE
000 ~ 255
000 ~ 007
008 ~ 015
016 ~ 131
132 ~ 139
140 ~ 181
182 ~ 189
190 ~ 231
232 ~ 239
240 ~ 247
9C
FUNCTIONS
DIMMER
0 100%
STROBE
Off
Open
Strobe: Slow
Fast
→
open
Slow Open Fast Close
Open
Slow Close Fast Open
Open
Random Strobe
Advertisement
Table of Contents
