Daewoo DWD-WD125 Series Service Manual page 42

rum Wa
5. MANUAL TEST MODE
- PCB and other electronic parts will be tested without water supply whether they are normal or not.
1) Process
: Press power button -> Press "SPIN" button 3 times with pressing "WASH" button -> "X X X" will be
shown on LED display-> Whenever pressing "Beeper" button 1 time, below process will be occurred.
- "X X X' : Program version display
Step Display
1 L_C
2 run
3 b1
4 b2
5 b3
6 b4
7 b5
8 b6
9 b7
10 L
11 H
12 C
13 P
14 U
15 bb
16 dr
17 L_O
2) More details
- When turn on 'LOCK' signal, all process is conducting normaly.
- In this case, BLDC Motor is not tested. In order to test it, select spin or rinse.
Details
Door Lock Close
001 Running times count
0 HALL-SENSOR ERROR count
0 IPM-FAULT ERROR count
0 Over-load ERROR count
0 Motor align ERROR count
0 Rpm checking ERROR count
0 Overvoltage ERROR count
0 Low voltage ERROR count
No use
Hot Valve
Cold Valve
Pre Wash Valve
No use
Bleach Valve
Drain Pump
Lock Open
41