Daewoo DWD-WD125 Series Service Manual page 31

rum Wa
3-2. Rinsing Cycle
1) Water Supply Cycle
① When selecting 'add water for rinsing', water is supplied to the water level of additional rinsing.
② Only cold water is supplied in rinsing cycle.
③ In the last rinsing, fabric softener is inserted by opening both cold water V/V and pre-washing V/V at
the same time.
2) Re-supply of Water
① Water level is checked 1 minute after starting of rinsing cycle. Then, water is re-supplied up to the
designated water level.
3) Drainage
① To administer drainage after completing washing at water temperature of 55℃ or higher, drainage is
carried out after dropping water temperature by supplying cold water to high level.
② When drainage cycle begins, drainage motor is continuously kept on.
4) Interim Spin-drying
① Interim spin-drying is administered up to the r.p.m designated per each course.
The following cycle begins if R spin-drying is not reached after 20 times of balance spin-drying.
② After completion of washing cycle, load sensing is carried out before the first interim spin-drying to
detect load. Then, the cycle proceeds to main spin-drying by differing standard unbalance values
according to the load.
30