Advertisement
Quick Links
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
1. Be sure to read these instructions thoroughly before opening and installing the 2018
Kymco 700 Soft Door Rear Window Combo. The installation is best done when the
temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if
conditions prevent installing in warmer weather it helps to store the adhesive Velcro at
room temperature prior to installation.
2. Carefully open the carton and remove the enclosure on a large flat surface that is clean
and free of dirt.
3. Check over the parts included in the carton with the parts list shown below:
Adhesive Velcro Hook Strips:
"
"
Snap Screw Studs
---------------------------------------------------------------------------
Adhesive Velcro Hook Strips:
"
The cab for you Kymco 700 is made up of 3 different components that work together to enclose
your vehicle. Install the cab in the following order.
1) Soft Doors
2) Rear Window
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
2018 Kymco 700
Soft Door Rear Window Combo
KY-700-2018-DRW01
"
"
"
"
"
"
"
"
"
Soft Doors
20 each------------3"
2 each------------42"
22 each ( 2 extra )
Rear Window
1 each------------40"
Advertisement
Related Manuals for FALCON RIDGE KY-700-2018-DRW01
Summary of Contents for FALCON RIDGE KY-700-2018-DRW01
- Page 1 2018 Kymco 700 Soft Door Rear Window Combo KY-700-2018-DRW01 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. 1. Be sure to read these instructions thoroughly before opening and installing the 2018 Kymco 700 Soft Door Rear Window Combo.
- Page 2 Soft Doors 1. Begin by holding the door up to the frame and attach it using the double-sided Velcro strips sewn perpendicular to the edge of the door. At each of the double-sided strips take one of the 3" adhesive Velcro strips and adhere it to the inside of the frame. Then wrap the double-sided strip around it so that the adhesive strip holds it firmly in place.
- Page 3 2. Next take the 38" adhesive Velcro strips and run it down the back of the roll cage facing towards the rear of the vehicle. Start at the bottom and work your way up the bar. You will see the double-sided Velcro tabs sewn along the back of the doors. See photo below. 3.
-
Page 4: Rear Window
REAR WINDOW 4. Begin by placing the 40" adhesive Velcro strip across the top of the roll cage. Make sure to place them on top of the bar. Photo below shows how it should look. 5. Next attach the sides of the Rear Window to the tabs on the back of the doors. See photo below. - Page 5 Cleaning and Storage Recommendations: Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution.
-
Page 6: Return Policy
- a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge... -
Page 7: Warranty
Warranty To The Owner of this Product: Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product.