Advertisement
Quick Links
3510-1 Port Jacksonville Pkwy, Jacksonville, FL 32226
CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is
Be sure to read these instructions thoroughly before opening and installing the enclosure.
The installation is best done when the temperature is 60
carton and unroll the enclosure on a large flat surface that is clean and free of dirt or other
material.
Check over the parts included in the carton with the parts list shown below:
Velcro hook strips
Velcro hook strips
Velcro hook strips
Snap Studs
Cab Enclosure
1. You must remove the windshield and top(if installed) before beginning
installation of the Soft Door Kit.
2. Begin by attaching the top of the door to the cross bars running front to back on
the roll cage using the supplied 19" adhesive Velcro strips. Pull the door up and
mark where the Velcro on the top of the door is going to hit the bar, make sure
that the cab is centered across the back by checking both sides and making sure
they both hit the front bars equally. Now apply the 19" adhesive Velcro on the bar
facing inboard, and attach the corresponding Velcro straps on the enclosure(see
fig. 2
800-213-7981
Instructions for Installation and Care of
Kawasaki
Soft Door Kit
KAW-SX-SDK01
FLAMMABLE.
24 each
2 each
2 each
17 each (1 extra)
2 doors
Mule SX
F or warmer. Carefully open the
°
3" long
8" long
19" long
Advertisement
Related Manuals for FALCON RIDGE KAW-SX-SDK01
Summary of Contents for FALCON RIDGE KAW-SX-SDK01
- Page 1 Instructions for Installation and Care of Mule SX Kawasaki Soft Door Kit KAW-SX-SDK01 CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is FLAMMABLE. Be sure to read these instructions thoroughly before opening and installing the enclosure.
- Page 2 Fig.2 3. Next you will work your way down the front of the door. Starting at the top you will see double-sided Velcro strips sewn to the edge of the cab. At these points you will take the 3” adhesive Velcro and wrap them around the bar and then wrap the double-sided strip around that to provide a secure grip.
- Page 3 3. A special cleaner/conditioner is available from Falcon Ridge that will greatly increase the service life of the cab enclosure. If needed, additional hook and loop sets are available, as well as other spare parts and hardware. Contact Falcon Ridge for information.
-
Page 4: Return Policy
- a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 800-213-7981 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns... -
Page 5: Warranty
Warranty To The Owner of this Product: Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product.