Can am commander aero-vent lexan windshield (6 pages)
Summary of Contents for FALCON RIDGE CA-COM-MAX-SDK01
Page 1
606-845-7439 Instructions for Installation and Care of Can-Am Commander Max Soft Door Kit CA-COM-MAX-SDK01 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done when the temperature is 70 degrees F.
Page 2
4. Next take the 30” adhesive Velcro strip and run it down the back of the roll cage facing towards the rear of the vehicle. They should match up with the double-sided Velcro tabs sewn along the rear of the soft door.
Page 3
5. Next take the 10” and 4” adhesive Velcro strips and place it on the around the door in several locations as shown in the photo below. Then affix the bottom of the front panel to it as shown in the second photo.
Page 5
7. Lastly, attach one last double-sided strip at the bottom rear of the front door as shown in the photo below.
Page 6
Cab to either extreme hot or cold temperatures when storing. 3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.