Advertisement
Quick Links
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the
product before removing protective film. Once the film is removed you cannot return the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the Can Am -Aero-Vent Lexan
Windshield.
1. Check over the parts included in the cartons with the parts list shown below:
2" Loom Clamps
1" Stainless Steels Bolts
Stainless Steel Washers
Plastic Thumb Nuts
Lock Nuts
Slide Fasteners
50" Rubber Gasket
Lexan Brace
Lexan Vent Sliders
Lexan Windshield
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by
peeling off the protective film. Next take the 50" piece of rubber gasket and starting at one end firmly
place across the bottom of the windshield. You may need to trim off excess gasket. The diagram below
show where to install the gasket.
2515 Bypass Rd. Flemingsburg, KY 41041
Instructions for Installation and Care of Can Am Commander
Aero-Vent Lexan Windshield
CA-COMMANDER -WD05
606-845-7439
6 each
12 each
16 each
8 each
4 each
8 each
1 each
1 each
2 each
1 each
Advertisement
Related Manuals for FALCON RIDGE CA-COMMANDER -WD05
Summary of Contents for FALCON RIDGE CA-COMMANDER -WD05
- Page 1 Instructions for Installation and Care of Can Am Commander Aero-Vent Lexan Windshield CA-COMMANDER -WD05 NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund.
- Page 2 3. Next install the sliding vent panel on the inside of the windshield as shown in the diagram on the next page. To install slide fasteners push through holes with thumbs until it is completely through the hole in the windshield and locked in place. 4.
- Page 3 6. Now you can install the top brace if you want. If you do not have a Falcon Ridge Cab enclosure to work with this windshield, the top brace is not needed but can be installed for extra strength. Below is a...
- Page 4 7. If you are using this windshield with a Falcon Ridge Cab enclosure then you will use the Top Brace to sandwich the cab material and seal off the inside from the wind. The diagram below shows how it will work.
- Page 5 Completed Windshield –Inside view Thank you for your purchase!
-
Page 6: Return Policy
Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.