Summary of Contents for FALCON RIDGE AC-WILDCAT-X-SDK01
Page 1
Instructions for Installation and Care of Arctic Cat / Textron Wildcat X Soft Door Kit AC-WILDCAT-X-SDK01 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is best done when the temperature is 70 degrees F.
Page 2
2. Next take the 8" and a 12” adhesive Velcro strips and run it down the back of the roll cage facing towards the rear of the vehicle. They should match up with the double-sided Velcro tabs sewn along the rear of the soft door.
Page 3
3. Next take the 8” adhesive Velcro strip and place it on the front fender as shown in the following photos. Then affix the bottom of the front panel to it as shown in the second photo.
Page 4
4. Last part of the door to attach is the bottom to the factory half-door. Take the 44” adhesive Velcro strip and attach it to the factory door to match up with the Velcro sewn to the bottom of the soft doors. The adhesive Velcro will cross the hinge of the door, take a knife and cut the adhesive Velcro at the hinge.
Page 5
Cab to either extreme hot or cold temperatures when storing. 3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.