FALCON RIDGE KU-RTVX900-RW01 Instructions For Installation And Care

Kubota rtv x900 soft rear window

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.

Be sure to read these instructions thoroughly before opening and installing the Kubota RTV X900 Soft Rear

Window. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature

affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive

Velcro at room temperature prior to installation.

1. Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.

2. Check over the parts included in the carton with the parts list shown below:

Adhesive Velcro Hook Strips:

Cab Enclosure

If any parts are damaged or missing please contact customer service at (606) 845-7439.

3. Begin by installing the Rear Window. Along the bottom of the rear window is a 53" long Velcro strip.

This will attach to the shelf under the expanded metal cage and along the top of the seat back. Take the

53" adhesive Velcro strip and adhere it up under the shelf with the Velcro facing down. Then attach the

bottom of the rear window making sure to center it and keep it straight. The photo below shows how it

should fit.

2515 Bypass Rd. Flemingsburg, KY 41041

606-845-7439

Instructions for Installation and Care of

Kubota RTV X900

Soft Rear Window

KU-RTVX900-RW01

15 each------------3"

2 each------------18"

1 each------------53"

1 panels

Table of Contents

Need help?

Do you have a question about the KU-RTVX900-RW01 and is the answer not in the manual?

Page 1 Kubota RTV X900 Soft Rear Window KU-RTVX900-RW01 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable. Be sure to read these instructions thoroughly before opening and installing the Kubota RTV X900 Soft Rear Window.
Page 2 4. Now pull the rear window up and attach it to the top bar across the back of the roll cage. The top and sides of the rear window has double-sided Velcro sewn along the edges. At each of these strips you will place a 3”...
Page 3 7. The Velcro strips down the sides of the Rear Window are not used unless you have the Falcon Ridge Soft Door Kit. If you do not have the doors just ignore this strip. They will be there if you ever decide to add the doors later.
Page 4 Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors’, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.