Dalsa ML-FM-16K07A Manual page 67

Display Name
Calibration Algorithm
Peak
Peak, Image Filtered
Set Target
Set Target, Image Filtered
Flat Field Calibration Target
Flat Field ROI Offset X
Flat Field ROI Width
Calibrate FPN
Calibrate PRNU
Flat Field Correction Current
Active Set
Factory Set
User Set 1
(1 thru 16)
Save Calibration
Load Calibration
Appendix A: GenICam Commands
Feature
flatfieldCorrectionAlgorithm
PeakFilter
TargetFiltered
flatfieldCalibrationTarget
flatfieldCalibrationROIOffsetX
flatfieldCalibrationROIWidth
flatfieldCalibrationFPN
flatfieldCalibrationPRNU
flatfieldCorrectionCurrentActiveSet
UserSet1
(1 thru 16)
flatfieldCalibrationSave
flatfieldCalibrationLoad
Description
Selection between four different PRNU
algorithms.
Peak Calculation of PRNU coefficients to
bring all pixels to the peak.
A low pass filter is applied to the
average line values before calculating
the coefficients. Use this algorithm if
the calibration target is not uniformly
white or if it is not possible to defocus
the image. Because of the low pass
filter, this algorithm is not able to
correct pixel-to-pixel variations and so
it is preferable to use the "Peak"
algorithm.
Target
Calculation of PRNU coefficients to
bring all pixels to the target value.
A low pass filter is applied to the
average line values before calculating
the coefficients. Use this algorithm if
the calibration target is not uniformly
white or if it is not possible to defocus
the image. Because of the low pass
filter this algorithm is not able to
correct pixel-to-pixel variations and so
it is preferable to use the "Target"
algorithm.
Sets the target value for the "Calibrate
PRNU" feature.
Set the starting point of a region of
interest where a flat field calibration
will be performed
Sets the width of the region of interest
where a flat field calibration will be
performed
Initiates the FPN calibration process
Initiates the PRNU calibration process
Selects the User PRNU set to be saved
or loaded.
Factory Factory set can only be loaded.
Only the PRNU values are saved or
loaded which is much faster than
saving or loading the full Factory or
User set.
Saves the User PRNU set specified by
flatfieldCorrectionCurrentActiveSet to
the camera.
Loads the User PRNU set specified by
flatfieldCorrectionCurrentActiveSet to
the camera and makes it active.
Standard
& View
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Guru
DFNC
Guru
DFNC
Guru
DFNC
• 67