Dalsa ML-FM-16K07A Manual page 64

Display Name
Rotary Encoder Direction
Counter Clockwise
Clockwise
Rotary Encoder Output
Mode
Input Line Debouncing
Period
Rotary Encoder Multiplier
Rotary Encoder Divisor
Rotary Encoder Rescaler
Order
Multiplier Divider
Divider Multiplier
Trigger Delay
Line Selector
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
Output Line Source
On
Off
Output Line Pulse Delay
64 •
Feature
rotaryEncoderDirection
CounterClockwise
Clockwise
rotaryEncoderOutputMode
Position
Motion
lineDebouncingPeriod
rotaryEncoderMultiplier
rotaryEncoderDivider
rotaryEncoderRescalerOrder
multiplierDivider
dividerMultiplier
TriggerDelay
LineSelector
GPIO 1
GPIO 2
GPIO 3
GPIO 4
GPIO 5
GPIO 6
outputLineSource
On
Off
outputLinePulseDelay
Description
Specifies the phase which defines the encoder
forward direction.
Inspection goes forward when the rotary encoder
direction is counter clockwise (phase A is ahead of
phase B).
Inspection goes forward when the rotary encoder
direction is clockwise (phase B is ahead of phase
A).
Specifies the conditions for the Rotary Encoder
interface to generate a valid Encoder output
signal.
Triggers are generated at all new position
increments in the selected direction. If the
encoder reverses no trigger events are generated
until it has again passed the position where the
reversal started.
The triggers are generated for all motion
increments in either direction.
Specifies the minimum delay before an input line
voltage transition is recognizing as a signal
transition.
Specifies a multiplication factor for the rotary
encoder output pulse generator.
Specifies a division factor for the rotary encoder
output pulse generator.
Specifies the order that the multiplier and divider
are applied.
The signal is multiplied before been divided.
The signal is divided before been multiplied.
Allows the trigger to the sensor to be delayed
relative to camera input trigger
Selects the physical line (or pin) of the external
device connector to configure.
External trigger or rotary encoder A.
External direction or rotary encoder B.
Output 1.
Output 2.
Output 3.
Output 4.
Selects which internal signal to output on the
selected line.
Current output line is set with
outputLineSoftwareCmd
Current output line is configured with
outputLinePulseDelay, outputLinePulseDuration,
and LineInverter.
Sets the delay (in µs) before the output line pulse
signal. Applicable for the OutputLineSource
feature.
Appendix A: GenICam Commands
Standard
& View
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner