Dalsa ML-FM-16K07A Manual page 26

The wire gauge of the power cable should be sufficient to accommodate a surge during power-up of
at least 3 amps with a minimum voltage drop between the power supply and camera. The camera
can accept any voltage between +12 Volts and +24 Volts. If there is a voltage drop between the
power supply and camera, ensure that the power supply voltage is at least 12 Volts plus this
voltage drop. The camera input supply voltage can be read using CamExpert. Refer to the section
on Voltage & Temperature Measurement for more details.
Mating GPIO Cable Assembly
Teledyne DALSA makes available for purchase an optional GPIO breakout cable (12-pin Female
Hirose to 13-Pos Euro Block), as shown in the following drawing. Use accessory number #CR-
GENC-IOP00 to order.
26 • Linea ML Multiline Monochrome / HDR CMOS Cameras