Table of Contents
Advertisement
2. Remove motor cover by lifting vertically. It is held in place with Tinnerman clips on the motor side shrouds and
front cover.
Item
1
Remove Drive Motor
1. Disconnect motor cable from IMDB.
2. Remove cable tie at rear of motor pan using side cutters.
NOTE: Make note of cable tie location over the heat shrink tubing to replicate location after replacement.
3. Loosen striding belt by loosening the two tensioning bolts at rear of the treadmill using an 8 mm Allen wrench.
4. Move front roller towards front of treadmill to loosen drive belt.
5. Remove drive belt from motor pulley.
NOTE: If replacing drive belt, front roller needs to be removed from frame.
Description
Motor Cover
Item
1
2
3
4
Page 19 of 98
Qty.
Description
Drive motor
Drive motor cable
Heat shrink tubimg
Cable tie
1
Qty
1
1
1
1
Advertisement
Table of Contents
