Table of Contents
Advertisement
2. Remove motor cover by lifting vertically. It is held in place with Tinnerman clips on the motor side shrouds and
front cover.
Item
1
Remove IMDB
1. Disconnect all cables from IMDB. Note the location of each cable.
2. Remove screw at rear wall of motor pan using a Philips screwdriver.
3. Remove four screws and three washers at bottom of MDB bracket using a long Phillips screwdriver.
4. Pull ferrite and ferrite bracket assembly away from IMDB and remove IMDB board.
Install IMDB
1. Place IMDB board in motor pan, aligning slots in bracket over holes in motor pan.
Description
Motor Cover
Item
1
2
3
4
Page 43 of 98
Description
Ferrite bracket assembly
IMDB board
Screw
Washer
Qty.
1
Qty
1
1
5
4
Advertisement
Table of Contents
