How To's - LifeFitness GO CONSOLE Service Manual

How To's

How To...Replace Display Console
Tools Required: Phillips screwdriver (Bike / Cross-Trainer), 6mm Allen wrench (Treadmill)
1. Remove screws (C) securing the console (A) to the console support (B).
2. Lift the console (A) enough to disconnect the wiring harness connectors.
3. Install new console in reverse order.
4. Run calibration if mounted to a treadmill - see pages 13-15.
Note: For consoles installed in metric system countries, enter DIAGNOSTICS and change UNITS OF MEASURE from
ENGLISH to METRIC.
How To...Replace the Programmed Console Board
Tools Required: Phillips Screwdriver
1. Remove Display Console as described in How to Replace Display Console.
2. Remove ve Phillips screws (A) and remove the back cover (B).
3. Disconnect all cables connected to the programmed console board (D).
4. Remove nine Phillips screws (C) that secure the console board (D) to the bezel (E).
5. Lift the console board (D) from the bezel (E).
6. Replace On/Off switch (F) if necessary.
7. Install new programmed console board in reverse order.
8. Run calibration if mounted to a treadmill - see pages 13-15.
37