Bike/Cross-Trainer Error Messages - LifeFitness GO CONSOLE Service Manual

Bike/Cross-Trainer Error Messages

The console can display two main error codes that may occur if there is a malfunction on the bike or cross-trainer. The
error codes are:
OFF displayed in Level Window "Resistance motor communication Error"
Stuck Key Error
The rst step to all error codes is to simply reset the power to the product to see if the
error will repeat. If the error does repeat, please refer to the following de nitions and
potential solutions to the problem the error is representing.
OFF displayed in Level Window - Resistance Motor Communication Error
(1) This error is set if the console does not see any movement in the resistance motor
after the console has sent a command for it to move.
(2) Power shall be turned off to the resistance motor and the level window shall display "OFF." The product shall continue
to operate but no changes to level shall be possible.
(3) Must cycle power to reset the error.
Probable Cause / Solution
Try a power reset for the product. Then check to see if error is still occurring when trying to change resistance.
Servo motor incorrectly calibrated. First, try Auto Calibration on the console, then see the Servo motor calibration sec-
tions contained within the base products service manuals.
Damaged electrical cable somewhere between the console and the servo motor. Check all cable connections to verify
continuity from the console to the Servo motor. Replace cables as needed.
Damaged/malfunctioning Servo motor - replace Servo motor.
Problem within the console - Replace the console or console circuit board.
Stuck Key Error
(1) This error identi es a stuck key on the console (C1, C3, R1, R3, RS1, RS3) or activity zone (X3, X5, X8, E3, E5).
(2) If the console detects a key is actuated for over 45 seconds, the error will display.
(3) The bike or cross-trainer must be power cycled to clear this error.
Probable Cause / Solution
When Stuck Key Error is displayed, the console automatically runs through a continual cycle to determine which keys
are stuck. In the HEART RATE window, a value will cycle between 0 and 5. At the same time, a value will be shown in
the RESULTS window. Note, when the value in the results window is not '0000' and also the corresponding value in
the HEART RATE window. With this information, refer to the chart on the following page to determine if the problem is
a key on the main console board or the activity zone:
Go Bike/Cross-Trainer Console
Console Board
Key Value in HR
Window (Row)
Pause 0
Enter 0
Arrow Left 0
Race Mode 0
Arrow Up 1
Arrow Right 1
Arrow Down 1
Goal WO 1
Reset 2
User Pro les 2
Settings 2
28
Activity Zone Membrane Switch
Value in Results Key
Window (Column)
0010
0020 Level Down
0040 Total Body
0080 Level Up
0010
0020
0040
0080
0010
0020
0040
Value in HR Value in Results
Window (Row) Window (Column)
0 0008
1 0004
2 0004