Treadmill Error Messages - LifeFitness GO CONSOLE Service Manual

Treadmill Error Messages

The console can display eight main error codes that may occur if there is a malfunction on the treadmill. The error codes
are:
• Elevation Direction Error
• OFF displayed in Incline Window 'an elevation error'
• Over-Speed Error
• Run-Away Error
• Speed Stall
• Speed Range Error
• Stuck Key Error
The rst step to all error codes is to simply reset the power to the product to see if the error will repeat. If the error does
repeat, please refer to the follow de nitions and potential solutions to the problem the error is representing.
Elevation Direction Error
(1) This error is intended to detect if the elevation motor is moving in the opposite direction commanded by the console
(2) Error is set upon calibration after a replacement of the Motor Controller or elevation motor.
(3) Must cycle power to reset the error.
Probable Cause / Solution
1. The replaced elevation motor is incorrectly wired at either the J4 connection or the BLK/WHT/RED motor wires on the
motor control board.
2. The BLK/RED elevation motor wires have been reversed on the motor control board.
30