Pin Authentication In Pairing; Pairing The Authentication Pin When Receiving A Pairing Request - Motorola APX 8000 User Manual

At the fringe areas of reception, both voice and tone quality will start to sound "garbled" or "broken". To
correct this problem, simply position the accessory and radio closer to each other (within the 10 meter
defined range) to re-establish clear audio reception.
NOTE: Once a COTS headset is paired to your radio, it is always connected. Therefore the
battery life of the accessory is aligned with the Talk Time power consumption, not the Standby
Time consumption.
Procedure:
Turn on the accessory. Then, place it close to the radio aligning the Bluetooth Pairing Location
(a blue dot) on the radio to the Bluetooth Pairing Location (a blue dot) on the accessory.
If the pairing process is successful, you hear an incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-pitched tone. The display shows Bluetooth
pairing failed. Repeat this step.
The radio tries to establish connection with the device once paired.
NOTE: If the connection fails within 6 seconds, you hear a decremental-pitched tone to indicate
that the device is unpaired. The display shows <Device Type> unpaired. Repeat this step
to re-initiate the pairing process.
If the connection is successful, you hear an incremental-pitched tone. The display shows <Device
Type> connected and the Bluetooth icon turns from
If the radio has the pairing record of the device and the connection fails, you hear a short, low-pitched
tone. The display shows <Device Type> connect failed.
7.25.2

PIN Authentication in Pairing

This feature only supports Model 3.5 and Model 2.5.
This feature allows your radio to verify the correct device to pair with using PIN authentication.
NOTE: The PIN authentication method is only applicable for Bluetooth version 2.1 and above.
7.25.2.1

Pairing the Authentication PIN when Receiving a Pairing Request

Procedure:
1 When the radio display shows <Device Friendly Name> pair request, perform one of
the following actions:
• To accept, press the Menu Select button below Ok.
• To reject, press the Menu Select button below Cncl.
Your radio only supports HSP, DUN, PAN, and SPP Bluetooth profiles.
When the pairing timer expires, the display shows <Device Friendly Name> pair
canceled and return to Home screen.
If you choose to accept the pairing process, the display shows Compare PIN: XXXXXX.
Chapter 7 : Advanced Features
to .
MN001425A01-AW
117