Sending Remote Emergency By Entering The User Id; Manually Refreshing The Remote Emergency List; Receiving Remote Emergency - Motorola APX 8000 User Manual

MN001425A01-AW
Chapter 7 : Advanced Features
7.10.5.2

Sending Remote Emergency by Entering the User ID

Procedure:
1 Press the programmed Remote Emergency button.
2 Press any digit key.
3 Enter the number of the user ID.
4 To send Remote Emergency, press the PTT button.
If the ID of the target radio is valid, your radio displays sending notification and saves the ID as the last
Remote Emergency ID.
If the ID of the target radio is invalid, your radio displays an invalid ID notification.
If your radio is in one of the following states, your radio plays a tone.
• Receive-only Channel
• Transmit Inhibit
• Out of Range
• Imbalance Coverage
If your radio receives acknowledgment, your radio displays a positive notification.
If your radio does not receive acknowledgment from the target radio, your radio displays a negative
notification.
7.10.5.3

Manually Refreshing the Remote Emergency List

Procedure:
1 Press the programmed Remote Emergency button.
2 To refresh the remote emergency list, press Rfsh.
Your radio displays List refreshed followed by the updated remote emergency list..
7.10.5.4

Receiving Remote Emergency

The remote emergency will only be launched if your radio has the emergency enabled. The receiving
radio displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
74