Selecting A Channel By Using Channel Search Button; Mode Select Feature - Motorola APX 8000 User Manual
Hide thumbs
Also See for APX 8000:
- Quick start manual ,
- User manual (112 pages) ,
- Quick reference card (2 pages)
Table of Contents
Advertisement
MN001425A01-AW
Chapter 5 : General Radio Operation
•
Select a channel using the radio menu Chan :
a.
or to Chan.
b. Press the Menu Select button directly below Chan .
c.
or
to the required channel or use the keypad to enter the channel number.
If the channel number entered is unprogrammed, the display shows Invalid entry.
Repeat this step.
d. Press the Menu Select button directly below Sel to confirm the selected channel.
•
Select a channel using the radio menu Channel Up or Channel Down:
a.
or
to ChUp or ChDn.
b. Press the Menu Select button directly below ChUp or ChDn.
Positions of ChUp and ChDn on the display may differ each time you release the Menu
Select button. Read carefully before you press.
5.3
Selecting a Channel by using Channel Search Button
This feature allows you to do a quick search for a specific channel in your radio by keying in the alias of
the channel.
Procedure:
1 Perform one of the following actions:
•
Press the preprogrammed Channel Search button.
•
or to CSrh and press the Menu Select button directly below CSrh.
A blinking cursor appears on the Channel Search screen.
2 Use the keypad to type or edit your channel name.
3 To initiate searching, press the Menu Select button directly below CSrh once the entry is done.
To exit this procedure, press the Menu Select button directly below Cncl .
One of the following scenarios occurs:
•
The display shows Searching. Once found, the display shows the matched channel name and the
radio changes its transmission to the selected channel.
•
If the radio is triggered to search for an empty entry, the display shows Invalid entry. Repeat
step 2
to search again.
•
If the entry does not match, the display shows Channel name not found.Repeat
search again; or press
5.4
Mode Select Feature
This feature only supports Model 3.5 and Model 2.5.
The Mode Select feature allows you to save the current zone and channel on your radio to one of the
Mode Select feature menus (MS01–MS05) on a programmable side button (MS01–MS13).
When programmed, pressing the button changes the transmission to the saved zone and channel.
When the Preconfigurable Preset Zone and Channel field is enabled, pressing and holding the
40
or the Menu Select button directly below Exit to exit.
step 2
to
Advertisement
Table of Contents
