Pin Authentication In Pairing; Pairing The Authentication Pin When Receiving A Pairing Request - Motorola APX 2000 User Manual

Bluetooth tones, Bluetooth menu and preprogrammed buttons must be preprogrammed by a qualified
radio technician. Check with your dealer or system administrator for more information.
When and where to use: The range of Bluetooth operation when using a MCW accessory is 10
meters line-of-sight communication. This is an unobstructed path between the location of the signal
transmitter (your radio) and the location of the receiver (your device or accessory).
Obstacles that can cause an obstruction in the line-of-sight include trees, buildings, mountains, cars,
and others.
For high degree of reliability, Motorola Solutions recommends to NOT separate the radio and the
accessory.
At the fringe areas of reception, both voice and tone quality will start to sound "garbled" or "broken". To
correct this problem, simply position the accessory and radio closer to each other (within the 10 meter
defined range) to re-establish clear audio reception.
NOTE: Once a COTS headset is paired to your radio, it is always connected. Therefore the
battery life of the accessory is aligned with the Talk Time power consumption, not the Standby
Time consumption.
Procedure:
Turn on the accessory. Then, place it close to the radio aligning the Bluetooth Pairing Location
(a blue dot) on the radio to the Bluetooth Pairing Location (a blue dot) on the accessory.
If the pairing process is successful, you hear an incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-pitched tone. The display shows Bluetooth
pairing failed. Repeat this step.
The radio tries to establish connection with the device once paired.
NOTE: If the connection fails within 6 seconds, you hear a decremental-pitched tone to indicate
that the device is unpaired. The display shows <Device Type> unpaired. Repeat this step
to re-initiate the pairing process.
If the connection is successful, you hear an incremental-pitched tone. The display shows <Device
Type> connected and the Bluetooth icon turns from
If the radio has the pairing record of the device and the connection fails, you hear a short, low-pitched
tone. The display shows <Device Type> connect failed.
7.25.2

PIN Authentication in Pairing

This feature allows your radio to verify the correct device to pair with using PIN authentication.
NOTE: The PIN authentication method is only applicable for Bluetooth version 2.1 and above.
7.25.2.1

Pairing the Authentication PIN when Receiving a Pairing Request

Procedure:
1 When the radio display shows <Device Friendly Name> pair request, perform one of
the following actions:
Chapter 7 : Advanced Features
to .
68012005014-HV
115