Replacing The Water Separator Insert - Beko CLEARPOINT S040 Installation And Operation Manual

CLEARPOINT ® water separator

9.5 Replacing the water separator insert

For the water separator insert to be replaced, the following prerequisites must be fulfilled and the preparatory tasks
must have been completed.
Tools
• Screwdriver - cross-head
size 2.5 mm
1. Open the bypass pipe if available
Illustration
1.
36 | 56
Prerequisites
Material
• New WS-insert
Preparation of installation
Description
1.
1. Close the shut-off valves upstream and downstream
of the separator or the respective system section and
depressurise the filter
2. When the BEKOMAT
from the bottom part of the housing.
For further information see the enclosed installation and
operating manual for the BEKOMAT
Installation and operation manual
Protective equipment
• Protective gloves (fluid-
resistant)
• Safety goggles with side shields
• Hearing protection
• Respiratory protection,
protection class FFP 3
• Safety footwear
is used, it must be disconnected
®
®