Attaching The Hotshoe; Closing The Housing - Ikelite 71722 Instruction Manual

Attaching the Hotshoe

1. Orient the hotshoe with the arrow on top pointing towards the front
of the camera.
Camera
hotshoe
mount
Housing
hotshoe
2. Slide the housing hotshoe into camera's hotshoe mount until it
stops.
The hotshoe must be all the way forward in the camera mount
»
for proper flash operation.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The rear housing o-ring does not require lubricant
to make a seal.
2. Place the back onto the housing front.
3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4. Place each lid snap into the corresponding hook on the housing
back.
17