Setting Up An External Strobe - Ikelite 71722 Instruction Manual

5. Press the port firmly towards the housing until the base of the
port is flush with the housing's port mount. If there is resistance,
remove the port and re-check that the thumbscrews are loosened
and the o-ring is properly lubricated.
6. Tighten all three thumbscrews while holding the port firmly towards
the housing. The thumbscrews should thread in completely until
the head touches the port or extension body. If the screws are
difficult to turn and/or they bottom out before their heads are flush,
it is an indication that the port is not properly aligned.
Proper alignment is critical to waterproof operation. Check
»
that your lens port is oriented correctly and fully seated before
entering the water.
Zoom/focus gear parts and installation vary depending on the
»
lens you are using. Refer to the instructions included with the
zoom or focus gear for detailed installation information.

Setting Up An External Strobe

We recommend attaching an external strobe for the optimal color and
clarity in a wide variety of photographic situations, including daylight
photography.
This housing provides a direct electrical connection to the camera's
external flash hotshoe via a manual flash hotshoe. An external strobe
may be triggered via electrical sync cord.
20