Table of Contents
Advertisement
6. Insert the Mounting Plate into the corresponding slot on the inside
bottom of the housing. Rotate the front aperture knob slightly to
assist Gear Ring engagement with housing gear. Slowly push the
camera all of the way forward until the back of the Mounting Plate is
flush with the back of the housing mount.
7. Orient the On/OFF control so that the legs of the "U" are on either
side of the camera lever.
8. Check the Gear Ring. If it has slipped backwards slightly, gently
push the top forward to engage with the gearing in the front of the
housing.
The camera's Aperture Ring does not rotate 360º. Do not force
»
the control to rotate past its natural stop. Forced over-rotation
may damage the housing's gearing.
Attaching the Hotshoe
1. If using a strobe connected by electrical sync cord, orient the
hotshoe with the arrow on top pointing towards the front of the
camera.
Camera
hotshoe
mount
Housing
hotshoe
2. Slide the housing hotshoe into camera's hotshoe mount until it
stops.
12
Advertisement
Table of Contents
