Installing The Camera - Ikelite 71722 Instruction Manual

Underwater housing for canon eos 77d, eos 9000d
Table of Contents

Advertisement

Installing the Camera

1. Remove any lanyard or neck strap which may be attached to the
camera.
2. Check to see whether the camera's lens will fit through the port
opening of the housing. If not, the lens will need to be removed
from the camera body and re-attached after the camera body is
installed in the housing.
3. Remove the camera mount plate from the housing.
4. Line the mount screw up with the camera's tripod socket. Use a flat
screwdriver to tighten the mount plate to the camera.
1/4-20 tripod
mount
5. Pull out on the housing control knobs to move the controls out of
the way.
6. Insert the mount plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until it stops.
7. Push housing control knobs in and check orientation with the
camera.
The camera may be attached to a tripod using the 1/4-20
»
threaded mounting hole on the bottom of the mount plate.
16
Mount screw
Camera
tripod socket
LENS

Advertisement

Table of Contents
loading

This manual is also suitable for:

200dl

Table of Contents