Attaching The Hotshoe - Ikelite 6973.06 Manual

4. Line up the Mounting Screw with the Camera Tripod Socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
1/4-20 Threaded Hole
5. Pull out on the housing control knobs to move the controls out of
the way.
6. Insert the Mounting Plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the Mounting Plate is flush with the Housing Plate Mount Top Rib,
page 5.

Attaching the Hotshoe

1.
DO NOT attach the Hotshoe if you are using a fiber optic
strobe. Once the Hotshoe is connected to the camera, the internal
camera flash is disabled.
2. Make sure the Hotshoe and camera contacts are clean.
8
1/4-20 Mounting Screw
Camera Mounting Plate
Camera Tripod Socket