Attaching The Hotshoe; Closing The Housing - Ikelite 6146.19 Manual

Attaching the Hotshoe

1.
DO NOT attach the Hotshoe if you are using a fiber optic
strobe. Once the Hotshoe is connected to the camera, the internal
camera flash is disabled.
2. Make sure the Hotshoe and camera contacts are clean.
3. Slide the Hotshoe onto the camera Hotshoe Mount.
4. Push the Hotshoe forward until it is unable to go any farther. The
Hotshoe must be pushed all the way forward to make proper
contact with the camera and provide TTL operation.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
2. Place the back onto the housing front.
3. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4. Place each lid snap into the corresponding hook on the housing
back.
12
Hotshoe Mount
Hotshoe