Attaching The Hotshoe; Closing The Housing - Ikelite 6961.09 Manual

6. Pull out on the housing control knobs to move the controls out of
the way.
7. Insert the Mounting Plate into the slot of the Mounting Plate Base.
Push the camera all of the way forward until the back of the
Mounting Plate is flush with the back of the Mounting Plate Base,
page 6.

Attaching the Hotshoe

1. Make sure the Hotshoe and camera contacts are clean.
2. Slide Hotshoe all the way forward into the Hotshoe Camera Mount.
Push the Hotshoe forward until it is unable to go any farther. The
Hotshoe must be pushed all the way forward to make proper
contact with the camera and provide TTL operation. Make sure
the Hotshoe wire does not interfere with any housing control
operations.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
10
Hotshoe Camera
Mount
Hotshoe