Attaching The Hotshoe; Closing The Housing - Ikelite 6970.03 Instruction Manual

5. Insert the mounting plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the mounting plate is flush with the back of the housing mount.
6. Pop up the flash before installing the camera into the housing
when triggering an external strobe. Once the camera is closed in
the housing, the flash CANNOT be raised.

Attaching the Hotshoe

Slide Hotshoe into Camera Hotshoe Mount until it stops.
NOTE: Hotshoe must be all the way forward in the Camera Hotshoe
Mount to ensure a good electrical connection.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main housing o-ring does not require lubricant
to make a seal.
2. Place the back onto the housing front.
10
Hotshoe
Camera Hotshoe Mount