Attaching The Hotshoe - Ikelite DLM200 Manual

4. Line up the Mounting Screw with the Camera Tripod Socket. Use a
coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
1/4-20 Threaded Hole
1/4-20 Mounting Screw
Camera Mounting Plate
5. Pull out on the housing control knobs to move them out of the way.
6. Turn camera ON and insert the Mounting Plate into the slot on
the inside bottom of the housing. Push the camera all of the way
forward until the back of the Mounting Plate is flush with the back of
the housing mount.

Attaching the Hotshoe

1. Make sure the contacts are clean.
2. Slide the hotshoe onto the camera with the LOCK marking towards
the back of the camera.
3. Push the hotshoe forward until it is unable to go any farther. The
hotshoe must be pushed all of the way forward to make proper
contact with the camera and provide TTL operation.
4. Rotate the hotshoe locking ring at the hotshoe base clockwise until
snug.
Camera Tripod Socket
9