Attaching The Hotshoe - Ikelite 6950.13 Manual

2. Check to see whether the camera's lens will fit through the port
opening of the housing. If not, the lens will need to be removed
from the camera body and reattached AFTER the camera body is
installed in the housing.
3. Remove the camera mounting plate from the housing.
4. Line up the Mounting Screw with the Camera Tripod Socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
1/4-20 Threaded Hole
5. Pull out on the housing control knobs to move the controls out of
the way.
6. Insert the Mounting Plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the Mounting Plate is flush with the Housing Plate Mount Top Rib,
page 5.

Attaching the Hotshoe

1. Make sure the Hotshoe and camera contacts are clean.
8
1/4-20 Mounting Screw
Camera Mounting Plate
Camera Tripod Socket