Lens Port; Storage - Ikelite 71722 Instruction Manual

2. NEVER leave your housing in a fresh water rinse tank, even if it is
the only system in the tank. Collisions with another person's gear
can cause scratches or damage to your equipment. Accidental
damage occurs most often in the rinse tank.
3. Rinse off any residual residue from the rinse tank with clean,
running fresh water.
4. Stow the housing in a shaded place where it is protected from
impact and overheating. If no shade is available, cover the housing
with a light colored towel or cloth.
5. Check the memory card capacity and battery life of your camera
and strobe(s). Recharge as necessary.
6. Always re-check o-ring seals after opening the housing or
removing the lens port.
7. Detach the cord plug or bulkhead cap and lubricate the threads,
o-ring(s) and sealing surface(s) every 2-3 days during continuous
use.

Lens Port

Treat the surface of the lens port like a camera lens. After use, rinse
and gently dry the outside lens port to avoid water spotting. Use only a
microfiber lens cleaning cloth to avoid scratches. To clean, use a mild
soap solution.
Do not rinse the inside of the lens port.
»
Do not use alcohol, cleaning agents, spray lubricants, Rain-X,
»
or other solvents on the housing or lens port. Use of an
incompatible chemical compound can damage the plastic and
o-rings, and may result in leaking.

Storage

1. Clean the housing and controls thoroughly prior to storage.
25