Attaching The Hotshoe - Ikelite 6961.08 User Manual

4. Line up the Mounting Screw with the Camera Tripod Socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
1/4-20 Threaded Hole
5. Pull out on the housing control knobs to move them out of the way.
6. Insert the Mounting Plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back
of the Mounting Plate is flush with the back of the Housing Plate
Mount, page 6.

Attaching the Hotshoe

1. Make sure the hotshoe and camera contacts are clean.
2. Slide the hotshoe onto the camera.
3. Push the hotshoe forward until it is unable to go any farther. The
hotshoe must be pushed all the way forward to make proper
contact with the camera and provide TTL operation. Make sure the
hotshoe wire does not interfere with any housing control operations.
1/4-20 Mounting Screw
Camera Tripod Socket
Camera Mounting Plate
9