Register Device With Pin; Update Server - Honeywell L5210 Series Installation And Startup Manual

LYNX Touch Installation and Setup Guide
Programming the Control

Register Device with PIN

This procedure is used to replace one LYNX Touch module with another.
SCREEN
Comm. Diagnostics
Setup
Communication
During the registration process the following messages may be displayed:
Message
Registering...
Registration Successful!
Registering – Try Later!
Registration Failed!
Invalid Configuration!
Timed Out.
Primary ID – Need PIN.

Update Server

This procedure is used to upload the Configuration File to the Server.
SCREEN
Comm. Diagnostics
1. Select "Comm. Diagnostics" The System displays the following options depending upon
the communication device that is installed:
Communication
Status
Communication
ID Numbers
2. Select "Setup Communication". The System advances to the Registration screen and
the following options are displayed:
Register
Device
Update
Server
3. Select "Register Device With PIN".
(provided by your Central Station, your dealer or an authorized AlarmNet
representative) on the displayed keypad then select "Done". (Refer to the
table below for applicable registration messages.)
Note: Register Device With PIN can be cancelled by selecting "Cancel". The registration
process is aborted and the message Registration Cancelled! is displayed.
The registration message is sent and the unit is waiting for the acknowledgement.
The PIN number is valid and module is registered and is now in full service and available
for alarm reporting to the Central Station. The old module is unregistered. Additionally,
AlarmNet sends a substitution alarm to the Central Station.
Error Message indicates the module is busy.
Error message followed by one of the messages below:
Indicates the configuration is invalid.
Displayed if no response to the registration request is received.
Indicates PIN that was entered is invalid.
1. Select "Comm. Diagnostics" The System displays the following options depending upon
the communication device that is installed:
WiFi Location
None
Use the down arrow to scroll to the next page of options. Use the
the previous page:
Communication
Status
ACTION
Ethernet
Information
Test
Communication
Register Device
With PIN
Factory
Defaults
Enter a 4-digit alphanumeric PIN number
Meaning
ACTION
Configure
WiFi
Test
Communication
- 36 -
Cell (OR) CDMA
Information
Setup
Communication
Ethernet
Information
Cell (OR) CDMA
Information
arrow to return to
Setup
Communication
Communication
ID Numbers