Operation With A Load-Shedder; Operation With The Tydom Application; Led Switch Off Mode - DELTA DORE Tybox 5701 FP Installation And User Manual

4. Operation with a load-shedder

If a load-shedder is connected to your receiver:
- switch heating off if load-shedding is requested.
When load-shedding is in progress, the green LED on the receiver flashes.

5. Operation with the Tydom application

Your RF6700 receiver can be paired using the TYDOM application.
Features
Programming
Setting the temperatures
Pre-heat function
Absence mode

6. LED switch off mode

When the function for switching off the LEDs os active:
- When powering up (or restoring power), the LEDs are in their "In progress" state.
- If the button has not been pressed after one minute, the LEDs switch off.
- A press of the button will authorise the illumination of the LEDS for one minute.
The backup and default pilot wire modes will still be signalled.
To enable/disable the function:
Press for 6 seconds, until the LED switches on without flashing.
> 6s
❶ Press the receiver button for 6
seconds until the red LED is on and
steady.
Release the button.
Via the Tydom app
(temperatures programmed in the app: special events, overrides,
Your equipment automatically determines the start-up time in order
to reach the temperature at the programmed time.
>3s
... ... ...
... ...
❷ The LED is flashing:
1 flash: function disabled
2 flashes: function active.
A short press enables you to switch
from one to the other.
Yes
Yes
scenario)
Yes
Yes
OFF
> 1'
❸ A 3-second press validates the
selection and exits the mode.
The LEDs switch off after 1 minute of
inaction.
8